Stainless Steel Ribbon Expansion Joints

tainless steel ribbon molds are easy to make using our two different sizes of Stainless Ribbon. The trick is to make sure you have expansion joints so your glass doesn’t crack as it fires. We’ll focus on two different types of joints today, a sleeve joint and a tab joint.

Materials for Ribbon Molds

Materials for Stainless Ribbon Molds

Materials:

3/4″ Stainless Steel Ribbon

Square

Fine Point Sharpie

Airline Snips

Flat nose pliers

Tab Joint

Tab joints are used on the outside of ribbon molds to give glass room to expand. We are using a 1/2″ ribbon for this example:

Using the square, make sure the end of your ribbon is square, then mark intervals at 1/2″ and 1″

Squaring up the ribbon

Fold the 1″ mark into a right angle, this is the part of the joint that holds the tab

Fold the 1/2″ mark all the way back down

Your folded part should look like this

on the other end of the ribbon mold, mark a tab that is slightly less than 1/2″

Fold this tab up to a right angle. The tab needs to slip into the joint, so make sure you fold in the right direction

Finished tab expansion joint

Circle mold ready to line and fill with glass

Sleeve Joint:

Sleeve joints are exactly what they sound like, a sleeve of stainless ribbon that holds the ends together, but allows them to also slide apart slightly as your glass expands and contracts. These expansion joints can be used on any ribbon mold, but are especially good for making hollow shapes inside larger pieces of glass. Let’s get started:

Mark a section of ribbon to use as a sleeve that is at least twice as wide as the ribbon. We are using 3/4″ ribbon, and using a 1.5″ sleeve

Center the ribbon over the sleeve and mark both sides

Fold the edges of the ribbon into a sleeve

Folded Sleeve

slip ends of ribbon into sleeve and crimp tight

Outside of sleeve ribbon

Finished ring mold inside larger ring

both molds lined with shelf paper, ready to fill with glass

Examples of mold shapes

Examples of Glass made in a ribbon mold

Tips and Tricks for Success

  • Always line ribbon molds with shelf paper
  • Ribbon molds can be used for tack or full fuse, and have been tested up to 1900 degrees for stability
  • For large or complex molds, it is wise to brace around the edges with kiln furniture to keep the mold and glass in place during fusing
  • for pot melts, the ribbon mold will need to be weighted down to prevent glass from flowing under it
  • make sure folds are perfectly square to ensure mold sits perfectly flat
  • ribbon molds can be reshaped after firing, although extensive bending will eventually produce metal fatigue and can cause breakage
  • CAUTION! Edges can be sharp

Bottle Glass Fish Sun Charm

What’s a Sun Charm?  A little something that’s more than a sun catcher, but not quite a wind chime.  I was in the mood to do some fusing and also use up a bunch of my jewelry making stash, so here we go!  Materials: Fused Bottle Glass Fish Jump Rings Split Rings...
Read More

Lentil Bead Molds – Instructions

Lentil Bead Molds – Instructions Materials needed: Lentil Bead Mold (any size, or ALL the sizes for extra fun) Kiln Wash Glass frit Step 1. Prepare the mandrels. Each bead kit ships with a dozen mandrels and a tube of bead release, so you’re all set to go when your...
Read More

Shelf Paper Burnout Time Lapse

If you’ve ever wondered why your shelf paper smells when you fire it, you are in luck!  We’ve made a time lapse video showing the organic binder burning out of the shelf paper as it fires.  Notice how the paper turns black and then white again, when the paper is white...
Read More